The usual cold water cylinder is for the general purpose of storage or container. In Plumber Kensington, we offer varied cold water cylinders. We have either 4 gallons or 25 gallons capacity up to full range capacity of 100 gallons.

Knowing how cold water cylinder works is an important aspect for its management. These cylinders must have a close and fitted lids/cover to ensure safety and uncontaminated supply. Additionally, it is sometimes an open cylinder located in the roof or outside of the house.


Installation is very easy. Just secure the cold water cylinder in its appropriate position. To secure it, you must use valve upon drilling the holes necessary for its position and then tighten it with the screw.
Management of distribution of the cold water cylinder is another aspect. You must use connectors that simply connect the main cylinder to the distribution pipes. However to reassure the position and accessibility of the cylinder when inevitable problem occurs, you must connect it within the plumbing system. To do this, attach the valve to the tap connector then further connect them to the compression fit. There are two different outlets for hot water and cold water. You have to make that these go to their respective valve then secure the pipe using clips. You can also adjust it if you want.

When the installation and all the cylinders have been secured, each must be refilled with water. You must observe this to know whether leaks or other problems are present. The beginning of the process is controlled by the stopcock. Upon turning it on, make sure that all the system is tight and the insulation is working. This inspection process is very crucial for you to know whether it is properly insulated and therefore the cylinder is set and the refilling of the cylinder is suitable for the need of your family. After that, you observe the quality of the water. The medium sized cylinder is the most appropriate for any household since it is always easy to refill and thus, you can maintain the quality of the water. Try the medium sized cylinder with tight fitting lid from Plumbers Kensington.


“